Gluing Tips
We have put together a short set of instructions on how to glue the supports on your signs.
Medium viscosity CA glue (Cyanoacrylate Super Glue and accelerator will be needed to bond successfully
First prime sign with accelerator
Be sure to prime the full length of the sign where the support goes.
Prime accelerator on sign supports.
Fit pieces together.
Place 3 drops of glue at 3 points on the supports.
Wait 10 seconds and the bond is complete.
Place 3 drops of glue at 3 points on the inside of supports.
Glue dries clear with no flashing or fogging
Remember keep glue and accelerator off the contacts of the sign!
Remember keep glue and accelerator off the contacts of the sign!